The operating steps of the lithium battery separator:

a) Turn on the main power supply and switch on the load.

b) Turn on the key switch on the main control device.

c) Press and hold the switch on the main control device to make the working state of the battery sorter change from PAUSE to WORK.

d) Turn on the computer and run the simulation test program.

Adjust the probe distance of the separator to be consistent with the distance between the test cell slot. The automatic sorter allows the xenon lamp of the sorter to flash 5-10 times.

Calibrate the separator using standard pieces, then test and sort the battery pieces. The test bench must be calibrated with standard cells before testing the sorted cells. After the automatic sorting machine test, the battery should be sorted, and the solar cell with different power is prohibited to mix and mix, and the file is divided to 0.1W. During the test, the operator must wear a finger sleeve, and it is forbidden to test and separate without a finger sleeve. When taking and placing the battery, it should be light as far as possible, and try not to make the battery be rubbed, resulting in damage to the anti-reflection film.

Battery separation is the first process of battery assembly production is also one of the important processes, now we introduce the purpose of battery electrical performance separation and precautions.

I. Purpose

Try to make each battery power in each component within the design range.

Ii. Precautions:

1, do not touch the battery with bare hands;

2, when working, the battery should be taken lightly;

3, the standard film should be calibrated before the startup test, and the standard film of different specifications should be calibrated when testing different specifications of battery chips;

4, regular check whether the equipment is in good condition;

5. Avoid looking directly at the light source during the test to prevent eye damage;

6, the automatic sorting machine should check the outer packaging for damage before unpacking the battery, if there is a photo record and report, if there is no damage can be unpacked to check the battery;

7, each open a pack should be used up as soon as possible to prevent oxidation. If it cannot be used up, it should be sealed and stored.

Due to the randomness of the production conditions of the battery, the performance of the battery produced is not the same, so in order to effectively combine the performance of the same or similar batteries together, the automatic sorting machine should be classified according to its performance parameters; Battery test sorting is to classify the battery by testing the size of its output parameters (current and voltage). To improve the utilization rate of the battery, make qualified battery components.