The operation of the lithium battery sorter requires skills, and it is of great significance to master certain operation methods for the correct use of the lithium battery sorter. Therefore, follow the small series to understand how to use the lithium battery separator correctly:

1, turn on the main power supply, turn on the load switch.

2. Turn on the key switch on the main control device.

3. Press and hold the switch on the main control device to make the working state of the battery sorter change from PAUSE to WORK.

4, open the computer, and run the simulation test program.

Adjust the probe distance of the separator to be consistent with the distance between the test cell slot. Let the xenon lamp of the sorter flash empty 5-10 times.

The battery is then tested and sorted using a standard wafer calibration separator and an automatic separator. The test bench must be calibrated with standard cells before testing the sorted cells. After the test sorting, the battery should be sorted out, and the solar cell with different power should be prohibited to mix and mix, and the file should be 0.1W. The operator must wear the finger sleeve during the test process, the automatic sorting machine is forbidden to test and separate without wearing the finger sleeve, and when taking the battery, it should be light as far as possible, and try not to make the battery be subjected to friction, resulting in damage to the anti-reflection film.

Battery separation is a process of battery assembly production is also one of the important processes, now we introduce the purpose and precautions of battery electrical performance separation.

I. Purpose

Try to make each battery power in each component within the design range.

Ii. Precautions:

1, do not touch the battery with bare hands;

2, when working, the battery should be taken lightly;

3, the standard film should be calibrated before the boot test, and the automatic selection machine should be calibrated with different specifications of the standard film when testing different specifications of the battery;

4, regular check whether the equipment is in good condition;

5. Avoid looking directly at the light source during the test to prevent eye damage;

6, before unpacking the battery, check whether the outer package is damaged, if there is a photo record and report, if no damage can be unpacked to check the battery;

7, each open a pack should be used up as soon as possible to prevent oxidation. If it cannot be used up, the automatic selection machine should be sealed and stored.

Due to the randomness of the production conditions of the battery, the performance of the battery produced by the automatic sorting machine is not the same, so in order to effectively combine the battery with the same or similar performance, it should be classified according to its performance parameters; Battery test sorting is to classify the battery by testing the size of its output parameters (current and voltage). To improve the utilization rate of the battery, make qualified battery components.